how to start gentoo after installation?

Message

Rosetta · Post by **Rosetta** » Sat Feb 19, 2011 4:09 pm

Hi,

I found an installion guide on the link "http://www.gentoo.org/doc/en/handbook/h ... xml?full=1".
for installing the version "install-amd64-minimal-20110217". I wonder if i need the livecd every time i restart the computer?

Regards!
Rosetta

DONAHUE · Post by **DONAHUE** » Sat Feb 19, 2011 5:00 pm

At the end of following http://www.gentoo.org/doc/en/handbook/h ... xml?full=1 comes step 10.d, reboot. If all has gone well the reboot will bring you a command line interface (with no help from the cd). At that point you can choose to install (emerge) a graphical user interface and applications.

amk · Post by **amk** » Sat Feb 19, 2011 5:01 pm

No. After step 10. Configuring the Bootloader the system is installed to boot from your hard drive.

Rosetta · Post by **Rosetta** » Sat Feb 19, 2011 5:33 pm

amk wrote:No. After step 10. Configuring the Bootloader the system is installed to boot from your hard drive.

Okej thanks! I was tired and i thought about breaking the installation process. That was why i wondered if i could do the remailning steps later or if i would begin from the first step again. Now i know how it is.

Thanks again!

/Rosetta