[solved]Twinview and mplayer. No Vsync on 2nd LCD normal?

[bl00dseeker]

I use twinview since yesterday. Everything fine, great thing nvidia did here. But one thing is annoying me. When i watch a movie on the 1st (left) LCD there is Vsync activ, so no tearing. When i move the movie to the 2nd (right) LCD there are sometimes small tearing effects. I read a little bit about the subject and it seems to be a known issue. Is there still no way to fix this? It seems to be only at mplayer. I played Quake3Arena, UT2004 wit 2560x1024 and no tearing there on any LCD.

Here my xorg.conf:
http://phpfi.com/260091

The Left LCD is a BenQ FP93GX and the Right LCD is a BenQ FP93GX+ so this should be fine.

thx

edit:
I found out that it depends on nvidia-settings, too and that one of the LCD had 76Hz and the other 75Hz.
Here the new xorg.conf if anybody has the same problem.
http://phpfi.com/260647
Btw: you should check the config in nvidia-settings depending on vsync, too.