dbus-1.0.1 missing qt3 use flag. Help! [solved]

Message

DieselPower · Post by **DieselPower** » Tue Dec 05, 2006 3:59 pm

I just upgraded dbus from 0.62-r1 to 1.0.1-r2 and ran revdep-rebuild, and now I get the below message when it tries to emerge k3b. dbus-1.x.x does not seem to have the qt3 use flag anymore. What do I do? (downgrading to 0.62-r1 wants to downgrade other stuff that I would like to keep) Thanks

Code: Select all

!!! ERROR: app-cdr/k3b-0.12.14 failed.
Call stack:
  ebuild.sh, line 1562:   Called dyn_setup
  ebuild.sh, line 665:   Called pkg_setup
  k3b-0.12.14.ebuild, line 56:   Called built_with_use 'sys-apps/dbus' 'qt3'
  eutils.eclass, line 1617:   Called die

!!! sys-apps/dbus-1.0.1-r2 does not actually support the qt3 USE flag!
!!! If you need support, post the topmost build error, and the call stack if relevant.

Captain_Loser · Post by **Captain_Loser** » Tue Dec 05, 2006 4:00 pm

I ran into this problem, but after I ran a revdep-rebuild, it went away. I have the qt3 use flag. Not sure why you would have a problem and I don't.. Do you have the qt4 use flag set?

namo · Post by **namo** » Tue Dec 05, 2006 10:18 pm

You have to

Code: Select all

emerge dev-libs/dbus-qt3-old

DieselPower · Post by **DieselPower** » Thu Dec 07, 2006 4:17 am

I just ran "emerge --resume --skipfirst" several times when revdep-rebuild failed, ran revdep-rebuild again and all was fine!

castor_fou · Post by **castor_fou** » Fri Dec 08, 2006 6:10 pm

it doesn't work for me.

It is still broken for :

Code: Select all

app-cdr/k3b-0.12.14
sys-apps/hal-0.5.7-r3
games-strategy/poker3d-1.1.20-r1

Martux · Post by **Martux** » Fri Dec 08, 2006 10:12 pm

Hello! After doing what been told, i still also get this error

Code: Select all

!!! ERROR: app-cdr/k3b-0.12.14 failed.
Call stack:
  ebuild.sh, line 1585:   Called dyn_setup
  ebuild.sh, line 666:   Called pkg_setup
  k3b-0.12.14.ebuild, line 56:   Called built_with_use 'sys-apps/dbus' 'qt3'
  eutils.eclass, line 1617:   Called die

!!! sys-apps/dbus-1.0.1-r2 does not actually support the qt3 USE flag!
!!! If you need support, post the topmost build error, and the call stack if relevant.

I have tried with and without the qt3 useflag.

jbdubbs · Post by **jbdubbs** » Sat Dec 09, 2006 5:30 am

Same problem. Not only that, but re-emerging HAL makes dbus downgrade to 0.62.........