[Solved] Atheros QCA6174 card with ath10k failed to load

[togooroo]

I am trying to compile a new kernel (5.15.52, though I've tried this on 5.19 with the same results) and I ran into a strange error. I am using an Atheros QCA6174, with the ath10k driver. Lsmod shows the module is loaded, and also lspci shows this, but it is not active. Ip a shows nothing, and OpenRC can't start my wifi connection. My dmesg (full output at the end) comes up with this:

Code: Select all

[    8.255389] ath10k_pci 0000:01:00.0: failed to alloc CE src ring 0: -12
[    8.255392] ath10k_pci 0000:01:00.0: failed to allocate copy engine pipe 0: -12
[    8.255393] ath10k_pci 0000:01:00.0: failed to allocate copy engine pipes: -12
[    8.255394] ath10k_pci 0000:01:00.0: failed to setup resource: -12
[    8.255443] ath10k_pci: probe of 0000:01:00.0 failed with error -12

I haven't found anything online about this issue, so hopefully other people know how to fix it? Thanks in advance.

config: https://pastebin.com/JzPZjSvL
dmesg: https://pastebin.com/NFCzVzu7
lspci -k: https://pastebin.com/z4eGiFet

[charles17]

I haven't found anything online about this issue, so hopefully other people know how to fix it? Thanks in advance.

What about https://forum.openwrt.org/t/solved-sett ... r/132443/2?

[togooroo]

I haven't found anything online about this issue, so hopefully other people know how to fix it? Thanks in advance.

What about https://forum.openwrt.org/t/solved-sett ... r/132443/2?

Oh thank you so much, I feel like an idiot now but it did work.