350 Kismet

Message

garyb · Post by **garyb** » Fri Feb 20, 2004 4:56 pm

Just emerged kismet for my aironet 350 pcmcia

But get this error when trying to start the app

Server options: none
Client options: none
Starting server...
Will drop privs to garyb (1000)
No enable sources specified, all sources will be enabled.
Source 0 (cisco): Using pcap to capture packets from eth1
FATAL: Source 0 (cisco): pcap reported netlink type 1 (EN10MB) for eth1. This probably means you're not in RFMON mode or your drivers are reporting a bad value. Make sure you have run kismet_monitor.
Starting UI...
FATAL: Could not connect to localhost:2501.
Terminating...
Done. Run kismet_unmonitor or eject and re-insert your card (or restart your
pcmcia services) to return your card to normal operation.
root@laptop garyb #

bryon · Post by **bryon** » Fri Feb 20, 2004 5:17 pm

you need to change a few settings in the kismet.conf file and make sure that the card is in RFMON like the error message says.

garyb · Post by **garyb** » Fri Feb 20, 2004 11:10 pm

I didnt think cisco aironet cards could do RFMON mode.... ?

dsegel · Post by **dsegel** » Sat Feb 21, 2004 3:38 pm

You'd get the cisco messages by using the default kismet.conf, so maybe it was never configured.

Did you run kismet_monitor first?

bryon · Post by **bryon** » Sat Feb 21, 2004 4:27 pm

I know that the cisco cards can go into RFMON for a fact, it can be done with the pcmica-cs cvs ones and the the kernel ones.

350 Kismet

350 Kismet

setup

yes they do