Can't configure internet (eth0)
Posted: Sat Nov 19, 2005 10:51 am
Hi. I'm from Poland. On Polish forum they helped me a lot but I still don't have an internet in Gentoo. I hope you'll be able to help me. When I type it shows I connect to net by PPPoE. When set everything in "adsl-setup" and then "adsl-start" it's "TIMED OUT". But this can be interesting: after typing "adsl-status" the message is I think this can be also useful: In windows I just set my username and password and it JUST WORKS. In Gentoo I've been fighting with this problem for about 2 weeks 
. Help me solve this problem!
Code: Select all
ifconfig eth0Code: Select all
Link encap:Ethernet HWaddr 00:E0:4C:E5:C2:24
BROAD MULTICAST MTU:1500 Metric:1
RX packets:55 errors:0 dropped:0 overruns:0 frame:0
TX packets:65 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:4500 (4.3 Kb) TX bytes:4092 (39 Kb)
Interrupt:16 Base address:0xcf00Code: Select all
adsl-status: Link is down (can't read pppoe PID file /var/run/adsl.pid.pppoe).Code: Select all
lspci -v
...
0000:03:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)
Subsystem: Realtek Semiconductor Co., Ltd. RT8139
Flags: bus master, medium devsel, latency 32, IRQ 16
I/O ports at bc00 [size=dfee0000]
Memory at dfefff00 (32-bit, non-prefetchable) [size=256)
Expansion ROM at 00010000 [disabled]
Capabilities: [50] Power Management version 2
...
