View previous topic :: View next topic |
Author |
Message |
Satay n00b
Joined: 26 Jul 2012 Posts: 2
|
Posted: Wed Aug 07, 2013 9:39 am Post subject: kernel panic - not syncing no init found |
|
|
Ставлю 2 системы на 1 машину.
fdisk -l
Code: |
Disk /dev/sda: 500.1 GB, 500107862016 bytes, 976773168 sectors
Device Boot Start End Blocks Id System
/dev/sda1 * 2048 206847 102400 7 HPFS/NTFS/exFAT
/dev/sda2 206848 163839999 81816576 7 HPFS/NTFS/exFAT
/dev/sda3 * 163840000 168034303 2097152 83 Linux
/dev/sda4 168034304 976773167 404369432 5 Extended
/dev/sda5 168036352 272893951 52428800 83 Linux
|
lilo.conf
Code: |
lba32
boot = /dev/sda
map = /boot/.map
#install = /boot/boot-menu.b # Note that for lilo-22.5.5 or later you
menu-scheme=Wb
prompt
delay = 50
vga = normal
image = /boot/vmlinuz-3.8.13
root = /dev/sda3
#root = /devices/discs/disc0/part3
label = Gentoo
read-only # read-only for checking
other = /dev/sda1
#other = /devices/discs/disc0/part1
label = Windows
table = /dev/sda
|
При загрузке Gentoo получаю Code: | kernel panic - not syncing no init found |
В чем может быть беда? |
|
Back to top |
|
|
eccerr0r Watchman
Joined: 01 Jul 2004 Posts: 9679 Location: almost Mile High in the USA
|
Posted: Thu Aug 08, 2013 9:54 pm Post subject: |
|
|
Ok, I apologize, no Russian at all in me.
First off I noticed your fdisk -l contains two active boot partitions. This is most certainly incorrect, there can only be one.
Next off, what are you planning on using as your primary bootloader (the first one that boots up?)
On my dual boot machine, Windows7 bootloader is the primary bootloader. Unfortunately I don't remember how I set this up, but basically I go through the windows bootloader, then the linux bootloader (which happens to be grub-0.99) which loads the kernel.
You have two Linux partitions, what are the function of each? What is the small one for? The root= needs to point to what you're using as your root partition.
One thing that I'm not sure of, since I haven't used lilo in a long time: Could you need "append = root=/dev/sda3" ?
Also was the kernel able to mount the partition at all? (probably did, but just to make sure), and how was your installation installed? Might need to recheck the Gentoo handbook to make sure that you untarred the stage3 on the right directory.
(another potential future issue: you may need loader=chainloader or something like that to boot windows with lilo). _________________ Intel Core i7 2700K/Radeon R7 250/24GB DDR3/256GB SSD
What am I supposed watching? |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|