View previous topic :: View next topic |
Author |
Message |
alavov n00b
Joined: 06 Feb 2013 Posts: 2
|
Posted: Wed Feb 06, 2013 5:34 pm Post subject: [solved] bridge and netplugd |
|
|
Hi All,
I have bridging set up as per Gentoo KVM Wiki and it works fine after boot.
However, if I unplug and plug back in the network cable, the bridge fails to start. I don't see any failure messages in the logs, just nothing about bridge or br0.
When unplugging:
Code: |
netplugd[4346]: eth0: state ACTIVE flags 0x00011043 UP,BROADCAST,RUNNING,MULTICAST,10000 -> 0x00001003 UP,BROADCAST,MULTICAST
netplugd[2481]: /etc/netplug.d/netplug eth0 out -> pid 2481
netplugd[4346]: eth0: state OUTING pid 2481 exited status 0
dhcpcd[5222]: br0: carrier lost
|
When plugging back:
Code: |
netplugd[4346]: eth0: state INACTIVE flags 0x00001003 UP,BROADCAST,MULTICAST -> 0x00011043 UP,BROADCAST,RUNNING,MULTICAST,10000
netplugd[3022]: /etc/netplug.d/netplug eth0 in -> pid 3022
netplugd[4346]: eth0: state INNING pid 3022 exited status 0
|
and that's it, no DHCP, no br0 activation.
How do I reactivate bridge after plugging in the cable?
thanks,
alavov
Last edited by alavov on Thu Feb 14, 2013 8:33 pm; edited 1 time in total |
|
Back to top |
|
|
AngelKnight Tux's lil' helper
Joined: 14 Jan 2003 Posts: 127
|
Posted: Thu Feb 07, 2013 1:58 am Post subject: |
|
|
(disclaimer: just an idea; I haven't tried it since I'm not at home...)
It's possible br0 is being treated as an interface subject to ifplug, if you have ifplugd installed. Possibly try adding Code: | modules_br0="!plug" | to /etc/conf.d/net? |
|
Back to top |
|
|
alavov n00b
Joined: 06 Feb 2013 Posts: 2
|
Posted: Thu Feb 14, 2013 8:33 pm Post subject: |
|
|
AngelKnight wrote: | (disclaimer: just an idea; I haven't tried it since I'm not at home...)
It's possible br0 is being treated as an interface subject to ifplug, if you have ifplugd installed. Possibly try adding Code: | modules_br0="!plug" | to /etc/conf.d/net? |
Thank you! Actually, it was the other way around - I needed to exclude eth0 from been "plugd" Code: | modules_eth0="!plug" | , but the idea is the same
It works now. |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|