Haifen n00b
Joined: 14 Aug 2005 Posts: 37
|
Posted: Fri Aug 08, 2008 10:49 pm Post subject: Setting up Silo on an Ultra V [resolved] |
|
|
Hi-
I'm trying to install Gentoo on an Ultra V (standard 64-bit install w/ a 64-bit kernel and a 32-bit userland). I've emerged silo, set up my silo.conf file, and run silo attempting to get the boot block set up properly. Unfortunately, upon booting (ide@3/disk@0,0) I get 'SProgram Terminated'. Any thoughts as to what's going on and how to fix it?
-Robin K.
-------------------------------------------
Indeed, all that was needed was to repartition so that I had a boot partition at the beginning of the disk. I believe my boot PROM wasn't able to address a disk past 1GB, which is what threw SILO off.
Last edited by Haifen on Sun Aug 10, 2008 9:37 pm; edited 1 time in total |
|