Problem with setting eth1 as default after gentoo install

[twister666]

Hello everyone!

i have 3 lan cards. when i used livecd i run the following command that fived it: dhcpcd eth1 but now this doesnt work. also when i was installing gentoo i configured my lan cards for internet. now i dont know what to do to fix it, can soeone help me with this pls

my working lan adapter is eth1 the eth0 & eth2 are not connected for now since i will probably use them for something else.

my /etc/conf.d/net has following:
config_eth0=( "dhcp")
dhcp_eth0="nodns nontp nonis"
config_eth1=( "dhcp")
dhcp_eth1="nodns nontp nonis"
config_eth2=( "dhcp")
dhcp_eth2="nodns nontp nonis"

these are my cards:
04:06.0 Ethernet controller: D-Link System Inc RTL8139 Ethernet (rev 10)
04:07.0 Ethernet controller: ADMtek NC100 Network Everywhere Fast Ethernet 10/100 (rev 11)
04:09.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)

Does anyone know how to fix it?
pls help me

[NeddySeagoon]

Moved from Networking & Security to Duplicate Threads.
_________________
Regards,

NeddySeagoon

Computer users fall into two groups:-
those that do backups
those that have never had a hard drive fail.