cdrecord problem

[Piaga]

Hi all..

I cannot work with cdrecord..
I put an IDE philips burner into my ultra 5..

these are the config:

kernel 2.4.28-sparc-r6

$ cdrecord --version
Cdrecord-Clone 2.01 (sparc64-unknown-linux-gnu) Copyright (C) 1995-2004 Jörg Schilling

the kernel seems to be ok..

hdd: attached ide-cdrom driver.
hdd: ATAPI 40X CD-ROM CD-R/RW drive, 8192kB Cache, (U)DMA
Uniform CD-ROM driver Revision: 3.12
Partition check:
/dev/ide/host0/bus0/target0/lun0: p1 p2 p3 p4
/dev/ide/host0/bus1/target0/lun0: p3
SCSI subsystem driver Revision: 1.00
scsi0 : SCSI host adapter emulation for IDE ATAPI devices

but this is the result

root@sparc ~ # cdrecord -v dev=/dev/hdd blank=all

Cdrecord-Clone 2.01 (sparc64-unknown-linux-gnu) Copyright (C) 1995-2004 Jörg Schilling
TOC Type: 1 = CD-ROM
scsidev: '/dev/hdd'
devname: '/dev/hdd'
scsibus: -2 target: -2 lun: -2
Warning: Open by 'devname' is unintentional and not supported.
cdrecord: Read-only file system. Cannot open '/dev/hdd'. Cannot open SCSI driver.
cdrecord: For possible targets try 'cdrecord -scanbus'.
cdrecord: For possible transport specifiers try 'cdrecord dev=help'.

root@sparc ~ # cdrecord dev=help
Cdrecord-Clone 2.01 (sparc64-unknown-linux-gnu) Copyright (C) 1995-2004 Jörg Schilling
Supported SCSI transports for this platform:

Transport name: sg
Transport descr.: Generic transport independent SCSI
Transp. layer ind.:
Target specifier: bus,target,lun
Target example: 1,2,0
SCSI Bus scanning: supported
Open via UNIX device: not supported

Transport name: pg
Transport descr.: SCSI transport for ATAPI over Parallel Port
Transp. layer ind.:
Target specifier: bus,target,lun
Target example: 1,2,0
SCSI Bus scanning: supported
Open via UNIX device: not supported

Transport name: ATA
Transport descr.: ATA Packet specific SCSI transport
Transp. layer ind.: ATAPI:
Target specifier: bus,target,lun
Target example: ATAPI:1,2,0
SCSI Bus scanning: supported
Open via UNIX device: not supported

Transport name: ATA
Transport descr.: ATA Packet specific SCSI transport using sg interface
Transp. layer ind.: ATA:
Target specifier: bus,target,lun
Target example: 1,2,0
SCSI Bus scanning: supported
Open via UNIX device: not supported

Transport name: RSCSI
Transport descr.: Remote SCSI
Transp. layer ind.: REMOTE:
Target specifier: rscsi@host:bus,target,lun
Target example: REMOTE:rscsi@host:1,2,0
SCSI Bus scanning: supported
Open via UNIX device: not supported


Please.. help

[yaneurabeya]

What's your kernel version? If it's 2.6.7+ (I believe... it might be 2.6.8+), don't use SCSI-IDE emulation since they fixed the lower level hardware access and burning works now without it.

Also, check your perms and make sure it's something like 0777 for /dev/hdd.