View previous topic :: View next topic |
Author |
Message |
bigmacx n00b
Joined: 01 Nov 2004 Posts: 9
|
Posted: Mon Nov 01, 2004 12:44 am Post subject: Can't compile kernel on Raq system |
|
|
Hi all,
I've just started today trying to get Gentoo installed on my cobalt Raq2 system.
I found the Kumba home dir documentation, which was very helpful and I've searched this forum for my problem, but I cannot get the kernel to compile.
when I run:
make vmlinux
I get:
make: mipsel-linux-gcc: Command not found
Any thoughts? make dep runs just fine and I ran make oldconfig using the config file in the cobalt area of Kumba's home dir.
TIA _________________ Gentoo forever baby! |
|
Back to top |
|
|
bigmacx n00b
Joined: 01 Nov 2004 Posts: 9
|
Posted: Mon Nov 01, 2004 6:36 pm Post subject: |
|
|
never mind. the cross-compiler option.
doh! _________________ Gentoo forever baby! |
|
Back to top |
|
|
Astral n00b
Joined: 17 Nov 2003 Posts: 19 Location: Mo, USA
|
Posted: Mon Dec 27, 2004 4:20 pm Post subject: |
|
|
Thank you SO MUCH! I had this same problem and been pulling my hair out. I just used Kumba's .config for the 2.6 kernel, it must have been set my default. You the man.!! |
|
Back to top |
|
|
|