| View previous topic :: View next topic |
| Author |
Message |
crayztechnique
n00b
Joined: 03 Apr 2016
Posts: 30
|
 Posted: Tue Apr 12, 2016 12:48 am Post subject: Network Missing After Install (sit0 instead of enp7s0) |
 |
|
ifconfig -a outputs the following
| Code: | lo: flags=73<UP, LOOPBACK, RUNNING> mtu 65536
inet 127.0.0.1 netmask 255.0.0.0
inet6 ::1 prefixlen 128 scopeid 0x10<host>
loop txqueuelen 0 (Local Loopback)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (o.o B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions
sit0: flags=128<NOARP> mtu 1480
sit txqueuelen 0 (IPv6-in-IPv4)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 |
My network was configured as enp7s0 and it's not showing up now. |
|
| Back to top |
|
 |
crayztechnique
n00b
Joined: 03 Apr 2016
Posts: 30
|
| Posted: Tue Apr 12, 2016 5:09 am Post subject: |
|
|
| Could not find any help on this. Got impatient and just reinstalled. Works fine now. |
|
| Back to top |
|
|
NeddySeagoon
Administrator
Joined: 05 Jul 2003
Posts: 54216
Location: 56N 3W
|
| Posted: Tue Apr 12, 2016 5:44 pm Post subject: |
|
|
crayztechnique,
Your kernel driver was not built, or not load or both.
_________________
Regards,
NeddySeagoon
Computer users fall into two groups:-
those that do backups
those that have never had a hard drive fail. |
|
| Back to top |
|
|
|
Networking & Security
