Blender Video Editing: Bleeding frame replacement

[CaptainBlood]

HI,
In the video I'm editing, a frame has a bleeding portion, whereas the previous & the next frame are fine.
Is there a way to compute an intermediary frame from two others, aimed for a replacement?
Thks 4 ur attention.

[oreo]

Are you asking a question about blender? (The CAD) If so, this seems a little off topic for the gentoo forums. You'll probably find more immediate advice elsewhere on the internet. Try the forums listed on blenders site. (https://www.blender.org/community/)

Although, I use blender regularly I'll give this a try.

Just so I understand: You have a video clip in blender which has an unusable frame. You need to replace that frame with something.

As far as I know there is know way to realistically calculate a subframe of a video. So you basically have a couple of solutions:
1. Re-shoot the clip.
2. Delete the frame. If it's only one frame it shouldn't be noticeable, but that also depends on the frame rate of the clip.
3. Use the frame immediately before or after the unusable frame. Again it shouldn't be too noticeable.

You could try doing some fancy scaling and cropping on one of the adjacent frames to use as the replacement frame but that just depends on the motion of the camera, and the content of the clip. But doing that might just end up looking weirder than just dropping the frame all together. (Hence why this is not really presented as an option.)

Hope this helps! Happy blending!

EDIT: lol just realized how long ago this was. Hope this helps anyone with the same issue. (Which is highly unlikely.)
_________________
"One does not simply, install gentoo."