bootstrap.sh terminated with signal 11 [segment fault]

[tschus]

hi all, i am on install step bootstrapping the system code
section 12: bootstrapping the system

scripts/bootstrap.sh does a ton of stuff, then gets down to business and bails with collect 2: ld terminated with signal 11 [segmentation fault]
right after a gcc for libintl.a

i tried to restart the bootstrap.sh and it bailed out at creating ./config_status with unable to handle paging request at virtual address ff13a507 and then there is an Oops message.

Oops, what did it do, spill its beer?

So how do I recover from this and get my machine up. I was going along so great.... until this.

DFI PS35-BL
Pentium 4 2.0Ghz 400FSB
512MB single stick PC2700 Corsair
Seagate IDE drive 9 gig (+32mb boot, +1024mb swap, rest of disk /)
Samsung 48E CD-ROM

USB disabled
SATA disabled
APIC disabled
AC97 onboard audio disabled
Lan onboard disabled

Video onboard - enabled
Broadcom GigE PCI network card - enabled

[hielvc]

Sig 11 or segfault is usely a sign of flaky hardware. Check your CPU temp, run memtest from the install cd, turn down your FSB. Been ther done that

hielvc