How to use kitchensync?

Message

eniacght · Post by **eniacght** » Fri Jun 03, 2005 9:08 pm

Hi,

i have a sharp zaurus and connected it with to gentoo. According to my syslog
usb 4-2: new full speed USB device using uhci_hcd and address 2
usb0: register usbnet at usb-0000:00:10.2-2, Sharp Zaurus SL-5x00
usbcore: registered new driver usbnet
usb0: no IPv6 routers present
it was found correctly. After that i did
ifconfig usb0 192.168.129.1 netmask 255.255.255.255 up
route add -host 192.168.129.201 usb0
and was able to ping it.

Now i don't know, where in kitchensync i have to tell, that kitchensync shall sync my kde kontact with the zaurus. It is not realy intuitive ...

Thanks,
Henning

sfabius · Post by **sfabius** » Tue Jun 14, 2005 2:24 am

This page might help. make sure to read the whole page for other great Z tips-