| View previous topic :: View next topic |
| Author |
Message |
Lares
n00b
Joined: 01 Feb 2003
Posts: 3
|
 Posted: Sun Feb 02, 2003 11:16 pm Post subject: SMC2632W - prism2_cs and my Troubles |
 |
|
I can't get my wireless card to work. I have emerged pcmcia-cs as well as linux-wlan-ng. PCMCIA works as I get the two beeps when I insert my card. (high,low). But everytime I emerge linux-wlan-ng it reads
Build Prism2.x PCMCIA Card Services (_cs) driver? (y/n) [n]
I need to get this to read Y in order to compile prism2_cs. How do I do it???
Later Days, 
_________________
Later Days |
|
| Back to top |
|
 |
otulp
n00b
Joined: 22 Apr 2002
Posts: 31
Location: Norway
|
| Posted: Mon Feb 03, 2003 1:18 am Post subject: |
|
|
| I'm just guessing, as I don't have wireless myself and don't read ebuilds fluently, but could the problem possibly be that you have not set the 'pcmcia' USE flag in /etc/make.conf? |
|
| Back to top |
|
|
Lares
n00b
Joined: 01 Feb 2003
Posts: 3
|
| Posted: Mon Feb 03, 2003 2:02 am Post subject: |
|
|
My flags are ass follows
USE="+gtk +gnome +x -alsa -kde -qt +wavelan +cardbus +pcmcia"
if that helps any.....
_________________
Later Days |
|
| Back to top |
|
|
otulp
n00b
Joined: 22 Apr 2002
Posts: 31
Location: Norway
|
| Posted: Mon Feb 03, 2003 2:23 am Post subject: |
|
|
I don't think those plus signs should be there. If you use a flag, it should just read 'flag', not '+flag' (the minus signs, however should be there for flags you want to exclude). Perhaps the system does not recognise your settings.
...unless developers have added support for that. My primary source of information here is http://www.gentoo.org/doc/en/portage-manual.xml. |
|
| Back to top |
|
|
otulp
n00b
Joined: 22 Apr 2002
Posts: 31
Location: Norway
|
| Posted: Mon Feb 03, 2003 2:38 am Post subject: |
|
|
An absolute must (methinks) is the utility 'ufed' for editing your USE flags. Just had to post one extra time because I like it so much.
ufed, that is - not posting  |
|
| Back to top |
|
|
|
Kernel & Hardware
