| View previous topic :: View next topic |
| Author |
Message |
queshaw
n00b
Joined: 11 Oct 2002
Posts: 12
|
 Posted: Thu Oct 17, 2002 4:52 am Post subject: How was kernel built for ut2003 livecd? |
 |
|
The livecd boots.
But after installing my system doesn't finish loading when booting from hard disk. Everything I've tried results in my computer hanging, if I have my maxtor ata100 adapter w/Promise PDC20267 chipset in the computer.
In particular, I enabled support for PDC20267. I also tried disabling both ide channels on the adpater (ide2=noprobe hde=none hdf=none ide3=noprobe hdg=none hdh=none). I tried various kernels as well.
Is the .config that was used for the cd, available anywhere? I'd like to compare.
Last edited by queshaw on Thu Oct 17, 2002 5:39 am; edited 1 time in total |
|
| Back to top |
|
 |
rac
Bodhisattva
Joined: 30 May 2002
Posts: 6553
Location: Japanifornia
|
| Posted: Thu Oct 17, 2002 5:09 am Post subject: Re: How was kernel built for ut2003 livecd? |
|
|
| queshaw wrote: | | Is the .config that was used, available anywhere? |
There are several in here, but I'm not sure which one you want.
_________________
For every higher wall, there is a taller ladder |
|
| Back to top |
|
|
queshaw
n00b
Joined: 11 Oct 2002
Posts: 12
|
| Posted: Thu Oct 17, 2002 6:30 am Post subject: |
|
|
Thanks. It says 2.4.19-xfs-r1 at boot.
I guess I'll just browse the files and see if there's something obvious I can try. |
|
| Back to top |
|
|
|
Installing Gentoo
