View previous topic :: View next topic |
Author |
Message |
122jdh n00b
Joined: 03 Jan 2013 Posts: 1
|
Posted: Thu Jan 03, 2013 6:06 am Post subject: IBook G3 Will Not Boot From CD |
|
|
I've been trying for days now to get a linux on my IBook G3:
OS: MAC OS X 10.3.9
600 MHz PPC 750FX (G3) CPU 512k level 2 cache
256 MB RAM (Original 128MB)
20 GB HDD
LG CD-ROM CRN-8245B
2X AGP ATI Mobility Radeon 16 MB of VRAM
I was using a CD-RW but I now have CD-Rs. I am burning the ISO at x8 the lowest my drive can write CD-Rs. I have the following burning software: Cyblerlink Power2Go 8, IMGburn, Nero and InfraRecorder. I burnt one at x2 with an older drive still get the same problem tho: When holding "C" to boot from the CD, the drive spins loudly like its reading, but then slows down. If I listen I can here the CD spin. The IBook will go to a gray screen for a while flicker to a black screen for less than a second, followed by the globe icon and finally the flashing folder/question mark, before booting the OS on the HDD. I go into Open Firmware and try these commands: "boot cd,\\tbxi" and "boot cd,\install\yaboot" but always end up with these errors; when my Ethernet cord is not plugged in: "can't open: enet:bootp" and when it is plugged in: "BOOTP/BSDP failed: no filename specified can't OPEN: enet:bootp" and when using my CD-RW: "block0 is bad can't open". And when I try and put it on the HDD and boot with either "boot hd:0,yaboot" or "boot hd:0,\\tbxi" I get this error: "DISK-LABEL: LOAD (NONINTERPOSED) not supportedload-size=0 adler32=1 LOAD-SIZE is too small". I have not reset NVRAM or PRAM (No idea what these are configured at, so Id rather not change them unless i really have to)
Does anyone have any experience with this? |
|
Back to top |
|
|
JoseJX Retired Dev
Joined: 28 Apr 2002 Posts: 2774
|
Posted: Sat Jan 05, 2013 6:46 am Post subject: |
|
|
Try to view the contents of the CD in OSX. If you can't see the files on the CD in OSX, it won't work to boot. If at all possible, try to burn on another type of CD-R (perhaps with an older or slower CD-R drive). If this model has Firewire, you can set up the HD over FW in target disk mode. _________________ Gentoo PPC FAQ: http://www.gentoo.org/doc/en/gentoo-ppc-faq.xml |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|