virt-manager and networking [solved]

kiksen · Guru Joined: 24 Jun 2002 Posts: 401 Location: Denmark

Hi.

I've installed kvm and added kernel options according to the Gentoo KVM docs. It work fine until the virtual network is started. Then I get:

Error starting network: internal error '/sbin/iptables --table filter --delete INPUT --in-interface virbr0 --protocol udp --destination-port 69 --jump ACCEPT' exited with non-zero status 1 and signal 0: iptables: Bad rule (does a matching rule exist in that chain?).

Any and all suggestions welcome.

VinzC · Posted: Fri Sep 17, 2010 11:28 pm Post subject:

Have you added NETFILTER support to your kernel? There are a couple of modules to enable there. See this.
_________________
Gentoo addict: tomorrow I quit, I promise!... Just one more emerge...
1739!

kiksen · Guru Joined: 24 Jun 2002 Posts: 401 Location: Denmark

I'll look into that when i get to work on monday. Thanks, i'll post the results.

kiksen · Guru Joined: 24 Jun 2002 Posts: 401 Location: Denmark

Sorry for the late reply, but I was offline for a couple of days...

I followed the guide and it works flawlessly from the command line. It seems I'm unable to specify a bridge name that will satisfy virt-manager.

So... I got it working, but not with virt-manager. Any hints here would be great

Thanks so far.

kiksen · Guru Joined: 24 Jun 2002 Posts: 401 Location: Denmark

Hmm. vde support is non-existing in virt-manager/libvirt. Thats fine - i'll resort to cmd-line as i like vde *much* more than bridges

VinzC · Posted: Fri Sep 24, 2010 1:53 pm Post subject:

Interesting...
_________________
Gentoo addict: tomorrow I quit, I promise!... Just one more emerge...
1739!