| View previous topic :: View next topic |
| Author |
Message |
emc
Guru
Joined: 02 Jul 2004
Posts: 564
Location: Cracow, Poland
|
 Posted: Wed Feb 25, 2009 6:20 pm Post subject: [solved] strange message: no DRQ after MULTWRITE_EXT |
 |
|
Hi,
I have brand new EeePC 1000H and I got from time to time on console message:
| Code: | hda: status timeout: status=0xd0 { Busy }
ide: failed opcode was: unknown
hda: no DRQ after issuing MULTWRITE_EXT
ide0: reset: success |
I'm a bit worry, it's new HW! Any ideas, do I need some hdparam tuning or what?
| Code: | 00:1e.0 PCI bridge: Intel Corporation 82801 Mobile PCI Bridge (rev e2)
00:1f.0 ISA bridge: Intel Corporation 82801GBM (ICH7-M) LPC Interface Bridge (rev 02)
00:1f.2 IDE interface: Intel Corporation 82801GBM/GHM (ICH7 Family) SATA IDE Controller (rev 02) |
Last edited by emc on Wed Mar 04, 2009 4:06 pm; edited 2 times in total |
|
| Back to top |
|
 |
emc
Guru
Joined: 02 Jul 2004
Posts: 564
Location: Cracow, Poland
|
| Posted: Thu Feb 26, 2009 12:13 am Post subject: |
|
|
It become serious! I can't finish compile kernel because:
| Code: | end_request: I/O error, dev hda, sector 82054575
hda: no DRQ after issuing MULTWRITE_EXT
hda: status error: status=0x58 { DriveReady SeekComplete DataRequest }
ide: failed opcode was: unknown
hda: drive not ready for command
ide0: reset: success
Aborting journal on device hda6.
ext3_abord called.
EXT3-fs error (device hda6): ext3_journal_start_sb: Detected aborded journal
Remountig filesystem read-only |
Please, anybody has any idea, what is wrong?!?! |
|
| Back to top |
|
|
emc
Guru
Joined: 02 Jul 2004
Posts: 564
Location: Cracow, Poland
|
|
| Back to top |
|
|
emc
Guru
Joined: 02 Jul 2004
Posts: 564
Location: Cracow, Poland
|
|
| Back to top |
|
|
|
Kernel & Hardware
