View previous topic :: View next topic |
Author |
Message |
nadamsieee Guru
Joined: 30 May 2003 Posts: 340 Location: Atlanta, GA, USA
|
Posted: Fri May 30, 2003 10:40 pm Post subject: integrated eth0 on Gigabyte 7VAX |
|
|
I'm having trouble getting eth0 recognized. My mobo is a Gigabyte 7VAX with integrated ethernet. Any help for a newb would be greatly appreciated. _________________ nadams (at) ieee (dot) org |
|
Back to top |
|
|
nadamsieee Guru
Joined: 30 May 2003 Posts: 340 Location: Atlanta, GA, USA
|
Posted: Fri May 30, 2003 10:50 pm Post subject: |
|
|
The mobo is of the KT400 series, and according to the pretty picture on the installation guide (I have looked at the actual hardware yet) the Onboard LAN Chip is a RTL8100BL. _________________ nadams (at) ieee (dot) org |
|
Back to top |
|
|
nadamsieee Guru
Joined: 30 May 2003 Posts: 340 Location: Atlanta, GA, USA
|
Posted: Sun Jun 01, 2003 8:34 pm Post subject: eth0 works, ifconfig was killing it... |
|
|
Ok, I did some heavy googling and found that the 8139too module does infact work for this particular chipset. So I investigated my setup and noticed that Gentoo was finding eth0 correctly when booting from the install CD. It was only after running that eth0 was dying a horrible death
So I'll do some searching on bugs.gentoo.org and post this as an install bug if needed. _________________ nadams (at) ieee (dot) org |
|
Back to top |
|
|
ascompltd Tux's lil' helper
Joined: 26 Sep 2002 Posts: 113 Location: UK
|
Posted: Tue Jun 03, 2003 11:07 am Post subject: |
|
|
I have just got hold of the board that you are talking about and having done a modprobe on the network device I can get eth0 configured |
|
Back to top |
|
|
nadamsieee Guru
Joined: 30 May 2003 Posts: 340 Location: Atlanta, GA, USA
|
Posted: Wed Jun 04, 2003 1:34 pm Post subject: |
|
|
Does running ifconfig kill eth0 for you? When I was installing, everything came up correctly until I ran ifconfig. When doing so, ifconfig display eth0 but then networking died. Running ifconfig again would not show eth0. _________________ nadams (at) ieee (dot) org |
|
Back to top |
|
|
nephros Advocate
Joined: 07 Feb 2003 Posts: 2139 Location: Graz, Austria (Europe - no kangaroos.)
|
Posted: Wed Jun 04, 2003 1:54 pm Post subject: Re: integrated eth0 on Gigabyte 7VAX |
|
|
nadamsieee wrote: | I'm having trouble getting eth0 recognized. My mobo is a Gigabyte 7VAX with integrated ethernet. Any help for a newb would be greatly appreciated. :D |
Hey! This guy is running Gentoo on a VAX!
...sorry, couldn't resist. _________________ Please put [SOLVED] in your topic if you are a moron. |
|
Back to top |
|
|
|