Joined: 28 Jun 2006
|Posted: Thu Aug 24, 2006 6:54 am Post subject: Silo Oddity
|Just when I thought that I had this part of it working...
I rebuilt my kernel and - according to [url]http://kryo.se/e250/sparcraid.txt the instructions[/url] I used to get it all going, only needed to re-run silo if I did this. Silo looks like it's doing the right thing but, when I reboot:
SILO Version 1.4.13
No config file loaded, you can boot just from this command line
Yes, I can. I just say boot: vmlinux root=/dev/md0 and off it goes.
If I do boot: cat /etc/silo.conf it does so, no problems.
This is my silo.conf:
partition = 1
root = /dev/md0
timeout = 50
image = /boot/vmlinux
label = Linux
image = /boot/vmlinux-22.214.171.124
label = Previous
Any ideas? Seems like those of us doing Gentoo on Sparc get far more of a challenge than the x86 guys!