View previous topic :: View next topic |
Author |
Message |
jesus.manzano n00b
Joined: 16 Dec 2004 Posts: 12
|
Posted: Fri Dec 24, 2004 9:20 am Post subject: Problem boot Ultra5 |
|
|
Hello,
When I boot my machine after install gentoo with kernel 2.4.28
this message appear in the screen :
I need help for solve this problem!!
CMD646: chipset revision 3
CMD646: chipset revision 0x3, MultiWord DMA Force Limited
CMD646: 100% native mode on irq 4,7e0
ide0: BM-DMA at 0x1fe02c00020-0c1fe02c00027, BIOS settings: hda:pio, hdb:pio
ide1: BM-DMA at 0x1fe02c00028-0c1fe02c0002f, BIOS settings: hda:pio, hdb:pio
hda: ST380011A, ATA DISK drive
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
hdc: HD-DT-STDVD-ROM GDR8163B, ATAPI CD/DVD-ROM drive
ide0 at 0x1fe02c00000-0x1fe02c00007, 0x1fe02c0000a on irq 4,7e0
ide1 at 0x1fe02c00010-0x1fe02c00017, 0x1fe02c0000a on irq 4,7e0 (shared with ide0)
hda: attached ide-disk driver.
hda: host protected area => 1
hda: 156301488 sectors (80026 MB) w/2048KiB Cache, CHS=9729/255/63, (U)DMA
hdc: attached ide-cdrom driver.
hdc: ATAPI 52X DVD-ROM drive, 256kB Cache, (U)DMA
Uniform CD-ROM driver Revision: 3.12
Partition check:
/dev/ide/host0/bus0/target0/lun0: p1 p2 p3 p4 p7 p8
TRAPLOG: Error at trap level 0x3, dumping track stack.
TRAPLOG: Trap level 1 TSTATE [0000004480009605] TPC[0000000000638294] TNPC[0000000000638298] TT[68]
TRAPLOG: Trap level 2 TSTATE [0000000080049405] TPC[000000000040f3bc] TNPC[000000000040f3c0] TT[68]
TRAPLOG: Trap level 3 TSTATE [0000000080049405] TPC[000000000040cd58] TNPC[000000000040cd58] TT[32]
TRAPLOG: Trap level 4 TSTATE [0000009911049404] TPC[fffffffffffffffc] TNPC[fffffffffffffffc] TT[1ff]
\|/ _____ \|/
"@' / . . \ '@"
/_| \ __ / |_\
\___U__/
swapper(1): TL1: Data Access Exception
TSTATE: 0000000080049405 TPC: 000000000040cd58 TNPC: 0000000040cd58 Y: fffe01cc Not tainted
g0: fffff80000bf5530 g1: 0000000000000080 g2: 0000000000004000 g3: 0000000000000000
g4: fffff80000000000 g5: 0000000000000080 g6: fffff8003fef4000 g7: 00000000007413e0
o0: 0000000140000010 o1: 0000000000000000 o2: 0000000000000010 o3: 0000000000000008
o4: 0000000000637ff8 o5: 0000000400000000 sp: fffff8003fef6f21 ret_pc: 00000000004b89a0
I0: 0000000140000000 I1: 0000000000000010 I2: 0000000000744d40 I3: 0000000000000000
I4: 1fffff0007fdf733 I5: 0000000000741000 I6: 0000000000741000 I7: 0000000000000008
i0: 0000000000744d28 i1: 0000000000655d00 i2: 0000000000000000 i3: 0000000000000000
i4: fffff8003f38f6c8 i5: 0000000000000000 i6: fffff8003fef6ff1 i7: 0000000000493034
Caller[0000000000493034]
Caller[0000000000493234]
Caller[0000000000492e44]
Caller[000000000049339c]
Caller[000000000055917c]
Caller[00000000006cd0cc]
Caller[00000000006ba678]
Caller[00000000004180c4]
Caller[0000000000419348]
Caller[0000000000444e94]
Instruction DUMP: 02c1496a 8b29700b ca814281 <9b29700b> 02c14966 8328b03e 8a116034 8a114001 82102018
kernel panic: Attempted to kill init!
Press L1-A to return to the boot prom |
|
Back to top |
|
|
jesus.manzano n00b
Joined: 16 Dec 2004 Posts: 12
|
Posted: Fri Dec 24, 2004 9:28 am Post subject: |
|
|
After press STOP + A
In the next boot in the screen appear:
......
hda: attached ide-disk driver.
hda: host protected area => 1
hda: 156301488 sectors (80026 MB) w/2048KiB Cache, CHS=9729/255/63, (U)DMA
hdc: attached ide-cdrom driver.
hdc: ATAPI 52X DVD-ROM drive, 256kB Cache, (U)DMA
Uniform CD-ROM driver Revision: 3.12
alloc_area_pte: page already exists
Partition check:
/dev/ide/host0/bus0/target0/lun0:<0> kernel panic: Attempted to kill the idle task!
In idle task - not syncing
Press L1-A to return to the boot prom |
|
Back to top |
|
|
jesus.manzano n00b
Joined: 16 Dec 2004 Posts: 12
|
Posted: Wed Dec 29, 2004 12:06 pm Post subject: |
|
|
Somebody help me???? |
|
Back to top |
|
|
jesus.manzano n00b
Joined: 16 Dec 2004 Posts: 12
|
Posted: Thu Dec 30, 2004 9:44 am Post subject: |
|
|
I think that the problem is in the kernel configuration.
I do next step's in the configuration.
emerge sparc-sources
cd /usr/src/linux; make menuconfig
make dep && make clean vmlinux image modules modules_install
cp arch/sparc64/boot/image /boot/kernel-2.4.28
And when I reboot my machine the next message appear:
/dev/ide/host0/bus0/target0/lun0: <1> Unable to handle kernel NULL pointer dereference
Somebody help me!!! |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|