| View previous topic :: View next topic |
| Author |
Message |
darklich14
n00b
Joined: 28 Feb 2003
Posts: 57
Location: Georgia Institute of Technology
|
 Posted: Sun Mar 28, 2004 8:10 pm Post subject: Strange dmesg flood message 2.6.1-benh1 |
 |
|
I'm not sure what this has to do with, but my dmesg is flooded with the following message:
IN from bad port 64 at c01f1c10
this appears about 100+ times, and I think things that should be printed out in dmesg before it are cut off becuase this takes up so much room. Anyone have any idea what this is? Here's the output:
| Code: |
darklich@darkbook hw2 $ dmesg
1c10
IN from bad port 64 at c01f1c10
IN from bad port 64 at c01f1c10
IN from bad port 64 at c01f1c10
IN from bad port 64 at c01f1c10
:
:
:
<REPEAT THIS ABOUT 200+ TIMES>
:
:
:
IN from bad port 64 at c01f1c10
IN from bad port 64 at c01f1c10
IN from bad port 64 at c01f1c10
IN from bad port 64 at c01f1c10
IN from bad port 64 at c01f1c10
IN from bad port 64 at c01f1c10
IN from bad port 64 at c01f1c10
IN from bad port 64 at c01f1c10
IN from bad port 64 at c01f1c10
IN from bad port 64 at c01f1c10
IN from bad port 64 at c01f1c10
IN from bad port 64 at c01f1c10
IN from bad port 64 at c01f1c10
IN from bad port 64 at c01f1c10
IN from bad port 64 at c01f1c10
IN from bad port 64 at c01f1c10
IN from bad port 64 at c01f1c10
IN from bad port 64 at c01f1c10
IN from bad port 64 at c01f1c10
IN from bad port 64 at c01f1c10
IN from bad port 64 at c01f1c10
i8042.c: i8042 controller self test timeout.
NET: Registered protocol family 2
ohci_hcd 0001:01:19.0: GetStatus roothub.portstatus [1] = 0x00010301 CSC LSDA PPS CCS
hub 2-0:1.0: port 1, status 301, change 1, 1.5 Mb/s
IP: routing cache hash table of 8192 buckets, 64Kbytes
TCP: Hash tables configured (established 262144 bind 65536)
ip_conntrack version 2.1 (5120 buckets, 40960 max) - 300 bytes per conntrack
ip_tables: (C) 2000-2002 Netfilter core team
NET: Registered protocol family 1
NET: Registered protocol family 17
hub 2-0:1.0: debounce: port 1: delay 100ms stable 4 status 0x301
kjournald starting. Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Mounted root (ext3 filesystem) readonly.
Mounted devfs on /dev
Freeing unused kernel memory: 148k init 4k chrp 8k prep
ohci_hcd 0001:01:19.0: GetStatus roothub.portstatus [1] = 0x00100303 PRSC LSDA PPS PES CCS
hub 2-0:1.0: new USB device on port 1, assigned address 2
usb 2-1: new device strings: Mfr=1, Product=3, SerialNumber=0
drivers/usb/core/message.c: USB device number 2 default language ID 0x409
usb 2-1: Product: Microsoft 3-Button Mouse with IntelliEye(TM)
usb 2-1: Manufacturer: Microsoft
drivers/usb/core/usb.c: usb_hotplug
bus usb: add device 2-1
bound device '2-1' to driver 'usb'
usb 2-1: registering 2-1:1.0 (config #1, interface 0)
drivers/usb/core/usb.c: usb_hotplug
bus usb: add device 2-1:1.0
hid 2-1:1.0: usb_probe_interface
hid 2-1:1.0: usb_probe_interface - got id
input: USB HID v1.10 Mouse [Microsoft Microsoft 3-Button Mouse with IntelliEye(TM)] on usb-0001:01:19.0-1
bound device '2-1:1.0' to driver 'hid'
Adding 393208k swap on /dev/hda11. Priority:-1 extents:1
EXT3 FS on hda12, internal journal
bus pci: add driver gem
sungem.c:v0.98 8/24/03 David S. Miller (davem@redhat.com)
eth0: Sun GEM (PCI) 10/100/1000BaseT Ethernet 00:03:93:d9:c7:e6
PHY ID: 4061e4, addr: 0
eth0: Found BCM5221 PHY
bound device '0002:02:0f.0' to driver 'gem'
orinoco.c 0.13e (David Gibson <hermes@gibson.dropbear.id.au> and others)
airport.c 0.13e (Benjamin Herrenschmidt <benh@kernel.crashing.org>)
bus macio: add driver airport
Airport at physical address 80030000
eth1: Station identity 001f:0001:0008:0046
eth1: Looks like a Lucent/Agere firmware version 8.70
eth1: Ad-hoc demo mode supported
eth1: IEEE standard IBSS ad-hoc mode supported
eth1: WEP supported, 104-bit key
eth1: MAC address 00:30:65:27:2D:85
eth1: Station name "HERMES I"
eth1: ready
airport: card registered for interface eth1
bound device '0.00030000:radio' to driver 'airport'
ide_pmac: Set UDMA timing for mode 2, reg: 0x1090038c
hda: Enabling Ultra DMA 2
blk: queue c0d86200, I/O limit 4095Mb (mask 0xffffffff)
ide_pmac: Set UDMA timing for mode 2, reg: 0x1090038c
hStart = 1048, hEnd = 1184, hTotal = 1344
vStart = 771, vEnd = 777, vTotal = 806
h_total_disp = 0x7f00a7 hsync_strt_wid = 0x910415
v_total_disp = 0x2ff0325 vsync_strt_wid = 0x860302
pixclock = 15384
freq = 6500
lvds_gen_cntl: 000d24a1
request_module: failed /sbin/modprobe -- char-major-226-0. error = 256
[drm] Initialized radeon 1.9.0 20020828 on minor 0
agpgart: Putting AGP V2 device at 0000:00:0b.0 into 1x mode
agpgart: Putting AGP V2 device at 0000:00:10.0 into 1x mode
eth1: New link status: Connected (0001)
request_module: failed /sbin/modprobe -- snd-card-0. error = 256
request_module: failed /sbin/modprobe -- snd-card-0. error = 256
request_module: failed /sbin/modprobe -- snd-card-0. error = 256
request_module: failed /sbin/modprobe -- snd-card-0. error = 256
darklich@darkbook hw2 $ uname -a
Linux darkbook 2.6.1-benh1 #4 Wed Mar 24 15:01:55 EST 2004 ppc 750FX PowerBook4,3 GNU/Linux
|
Thanks for any help!
_________________
-Lyo |
|
| Back to top |
|
 |
BradN
Advocate
Joined: 19 Apr 2002
Posts: 2391
Location: Wisconsin (USA)
|
| Posted: Mon Mar 29, 2004 5:08 am Post subject: |
|
|
I think i8042 is the keyboard controller - the message right after those seems to indicate these failing in requests are part of the self test for it or something.
I'd suggest trying a different kernel version. This seems like a really strange problem because I imagine anyone testing that particular version has a i8042 compatable keyboard controller and should have seen the messages, unless there are other circumstances that trigger it. |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
Gentoo on PPC
