| View previous topic :: View next topic |
| Author |
Message |
ddc
Guru
Joined: 29 Aug 2006
Posts: 527
|
 Posted: Fri Jan 08, 2010 4:28 pm Post subject: Touchscreen |
 |
|
hi
any guide about how (and what emerge) calibrate a Touchscreen ?
i'd like not to use HAL (cause the target is embedded, like Neo openmoko)
any help/guide ? |
|
| Back to top |
|
 |
roarinelk
Guru
Joined: 04 Mar 2004
Posts: 312
|
| Posted: Sat Jan 09, 2010 7:21 pm Post subject: |
|
|
You can either use "tslib" (for Qt embedded, ...), or with a new enough X, the evdev
driver also supports touchscreens as long as they are supported by the kernel and
exported as "event" devices; then you need to play around with the calibration with
the xinput tool. |
|
| Back to top |
|
|
ddc
Guru
Joined: 29 Aug 2006
Posts: 527
|
| Posted: Tue Jan 12, 2010 5:49 pm Post subject: |
|
|
| roarinelk wrote: | You can either use "tslib" (for Qt embedded, ...), or with a new enough X, the evdev
driver also supports touchscreens as long as they are supported by the kernel and
exported as "event" devices; then you need to play around with the calibration with
the xinput tool. |
thk U
about QT, is it possible to emerge it ? if so, which is the ebuild name ? i can't find in portage |
|
| Back to top |
|
|
roarinelk
Guru
Joined: 04 Mar 2004
Posts: 312
|
| Posted: Thu Jan 14, 2010 8:12 am Post subject: |
|
|
| ddc wrote: | | roarinelk wrote: | You can either use "tslib" (for Qt embedded, ...), or with a new enough X, the evdev
driver also supports touchscreens as long as they are supported by the kernel and
exported as "event" devices; then you need to play around with the calibration with
the xinput tool. |
thk U
about QT, is it possible to emerge it ? if so, which is the ebuild name ? i can't find in portage |
No ebuild; just unpack the qt-everywhere-* source tarball, adjust the incdir/libdirs
in mkspecs/qws/<your-toolchain>/qmake.conf to point to where you stored
your ARM libs and headers, adjust your toolchain if necessary and then cross-build it.
The configure script is a bit picky about what you enable;
you also might need to play a bit with the libdir/incdir paths until qmake correctly picks
up and links all external libraries you have enabled...
You could emerge the "standard" x11-based Qt ebuilds too, it just takes a _long_ time
to build and you need X; qt-embedded can use a framebuffer or EGL/openvg if you have
a capable cpu. |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
Gentoo on Alternative Architectures
